Bargraph FX-B101 Lynx A low cost red or optional green, 101 segment bargraph in a 36x144 case, providing a direct connection to most sensors for monitoring and measurement applications. PRICED FROM $150 to $220 For ordering bargraphs call: 1-800 TEXMATE (1-800-839-6283)

Complete Data Sheet Download PDF 8 Pages 688K In order to read the PDF, you will need Adobe Acrobat Reader. Its FREE!

FEATURES • Optional red or green 101 segment bargraphs. • Auto-sensing AC/DC power supply with operational voltages between 85-265 VAC or 95-370 VDC as standard, and an optional low voltage supply operating between 12-36 VAC or 10-60 VDC. • Optional isolated 4-20 mA analog output that can be used to drive an external process device such as a chart recorder, remote display, or for retransmission to a central control room. • Center zero setting, header selectable. • Provision for external brightness setting switch (by connecting the DIM to the GND pin on the back of the meter). • Automatic averaging (to speed up display response). • Optional NEMA-4 front cover. • Direct connection of ACV, ACA, thermocouples, RTDs, and position sensors to interchangeable input signal conditioner eliminates the need for most external transmitters. • 24 V excitation is available to power external 4/20mA transmitters. • 5 or 10 V DC excitation is provided for resistance bridge type sensors. • Upwards of 30 interchangeable input signal conditioners available covering: – AC current – AC voltage – DC current – DC voltage – Position – Process loop – Prototype – Resistance – Temperature MODULE COMPATIBILITY LYNX FAMILY: Accepts more than 24 different Input Signal Conditioners approved for Texmate’s Lynx Family of meters. Some of these can be seen on pages 4 and 5. New products are constantly being developed. See www.texmate.com for an up to date listing. SPECIFICATIONS Output Options: Analog ...... Isolated 4-20 mA Internal Resolution: ...... 16-bits Conversion Mode: ...... Single slope, auto zero Accuracy: ...... 0.05% of full scale input ±1 segment Conversion Rate: ...... 5 samples per second Temp. Coefficient: ...... 50 ppm/ °C (Typical) Display: ...... 101 segment red or green Bar Indication: ...... Over range flashing Power Requirements: High Voltage: ...... Between 85-265 VAC or 95-370 VDC Low Voltage: ...... Between 9-32 VAC or 10-60 VDC Consumption: ...... Approximately 3.5 watts Warm Up Time: ...... 30 seconds Operating Temp.: ...... 0-50 °C Bargraph Resp. Time: ...... 0.5 Seconds